Home

Digital Clamp Multimeters

Digital Voltmeter Modules

Cables, Probes, Bags

Fuses for Multimeters

Milliohmmeters

LCR Meters and Component Testers

Energy Meters

Insulation Meters

Earth Resistance Meters

Electrical Installation Safety Testers

Cables-Voltage-Phase Testers

Magnetic Field Detectors

Power Line Analyzers

Signal Generators

Digital Oscilloscopes

Environmental Measures

Thermometers and Sensors

IR Thermal Imaging Cameras

Hygrometers

Anemometers and Pressure Gauges

Phonometers

Luxmeters

Chemical-Physical Characteristics

Set of Measuring Instruments

Tripods

Carrying cases

Accessories

There are 69 products.

Sort by:

PeakTech 2030 - Digital Multimeter 6000 Counts, Bar Graph, 1000V, True RMS

Digital Multimeter 6000 Counts, Bar Graph, 1000V, True RMS The PeakTech 2030 was developed for professional use, it has a double-insulated injection-molded housing with an anthracite-colored rubber coating, a service compartment on the back, through which not only the battery can be replaced, but also the fuses can be exchanged. The device has an inverted LCD display with 6,000 Counts and Bar Graph. It is Autorange and supports measurements for DCV, ACV, DCA, ACA, Ohm, Cap, Hz, °C, °F, diode and continuity test. Due to the high overvoltage category CAT III 1000V, you can use this device safely on electrical installations and systems.

$71.51

PeakTech 3432 - Multi-Function Fuse Locator, with NCV Detector and RCD Tester

Multi-Function Fuse Locator, with NCV (Non Contact Voltage) Detector and RCD (Residual Current Device) Tester The PeakTech 3432 is a multi-function measuring device which locates fuses in a circuit, detects the presence of voltage, tests RCD devices. It consists of a combination of a transmitter and a receiver. Both are used to locate the fuses, the receiver alone is used to detect voltages and the transmitter alone, plugged into an outlet, is used to test the RCDs. This combination of functions of the PeakTech 3432 simplifies a lot the work of an experienced electrician as well as of a novice user.

$54.15

5305A - pH-Meter and Thermometer (2-in-1)

pH-Meter and Thermometer (2-in-1) The PeakTech 5305A is a 2-in-1 pH meter that is operated with one hand and measures the pH and temperature in °C or °F of liquids at the same time. Both measured quantities are displayed on the LCD display with permanent backlight. Attached to the sturdy and waterproof housing is the easily replaceable sensor head, which includes the sensor for measurement of PH and temperature.

$36.79

Meter of pH, Electrical Conductivity (EC) and Temperature (3-in-1)

Meter of pH, Electrical Conductivity (EC) and Temperature (3-in-1) The PeakTech 5306 is a 3-in-1 pH meter that is operated with one hand and measures, at the same time, the pH or the Electric Conductivity (EC) in µS/cm, and the temperature in °C or °F, of liquids. Both measured quantities are displayed on the LCD display with permanent backlight. Attached to the rugged and waterproof housing is the easily replaceable sensor head, which includes the sensor for PH or EC measurement and temperature measurement.

$46.55

5307 - 4-in-1 Meter for pH, Electric Conductivity (EC) , Total Dissolved Solids (TDS), Temperature

4-in-1 Meter for pH, Electric Conductivity (EC) , Total Dissolved Solids (TDS), Temperature This 4 in 1 meter with one-hand operation measures: - The pH value of liquids via the galvanic voltage difference between acidic, neutral and basic liquids; - The conductivity EC in µS/cm is via two electrodes on the sensor head; - The TDS value for the total dissolved solids;. - The liquid temperature, displayed simultaneously on the second line of LCD display that is permanent backlight. Attached to the sturdy and waterproof housing is the easily replaceable sensor head, which includes the sensor for PH/EC/TDS and Temperature measurement.

$54.15

PeakTech 5310A - pH Meter with External Probe

pH Meter with External Probe Aqueous liquid pH value meter that uses a removable probe for quick and accurate evaluation of the measurement based on the potential difference generated at the tip of the probe by acidic, neutral and basic liquids. This device has two potentiometers for the calibration of the pH4 and pH7 values and a suitable screwdriver and three calibration buffer solutions are supplied. The measured values are displayed on the large LCD display with white backlight. It is powered by a standard 9V battery, for continuous use. This instrument, with its large display and complete range of accessories, is particularly suitable for both teaching and research.

$75.85

PeakTech 1286 - Digital Oscilloscope, 2 Channels, 100 MHz, 1 GS/s total, PC based with USB & LAN

Digital Oscilloscope, 2 Channels, 100 MHz, 1 GS/s total, PC based with USB & LAN This small and powerful PC oscilloscope is ideal for mobile use on a laptop or for permanent installation in control cabinets. For fast display of any incoming waveform one press of the autoset button is enough and the oscilloscope itself will search for the best possible display. Of course, all models in this series have an XY mode and an FFT function. Data transfer to the PC takes place via an isolated LAN connection, using a supplied AC adapter to power the oscilloscope, or via the USB interface, whereby the unit is directly supplied via USB interface.

$423.11

PeakTech 1331 - Digital Oscilloscope, 4 Channels, 100 MHz, 1 GS/s total, PC based with USB & LAN

Digital Oscilloscope, 4 Channels, 100 MHz, 1 GSa/s total, PC based This newly developed 4-channel PC Oscilloscope is ideal for mobile use on a laptop, for permanent installation in control cabinets, for industrial equipments and many other applications where a small, lightweight and powerful oscilloscope is required. The measurement data can be directly transferred to the PC via USB or LAN network with the included PC software. The oscilloscope has an insulated LAN network interface through which the data can be transmitted remotely in local area networks.This allows to install the device in electrical systems and allows you to do data acquisition comfortably from the workplace. The interface isolation ensures the maximum security for the user and the computer system.

$596.74

PeakTech 1326 - Digital Oscilloscope, 4 Channels, 70 MHz, 1 GS/s total, PC based with USB & LAN

Digital Oscilloscope, 4 Channels, 70 MHz, 1 GS/s total, PC based with USB & LAN This powerful 4-channel oscilloscope is ideal for mobile use on a laptop or permanent installation in control cabinets. To quickly display each incoming waveform, simply press the Autoset key and the oscilloscope itself searches for the best possible display. With Autoscale, the scaling of the time base can be adjusted in a user-friendly manner. Data transfer to the PC takes place via an isolated LAN interface using a supplied AC adapter to power the oscilloscope, or via the USB interface which also powers the oscilloscope.

$531.63

Showing 61-69 of 69 item(s)