Home

Digital Clamp Multimeters

Digital Voltmeter Modules

Cables, Probes, Bags

Fuses for Multimeters

Milliohmmeters

LCR Meters and Component Testers

Energy Meters

Insulation Meters

Earth Resistance Meters

Electrical Installation Safety Testers

Cables-Voltage-Phase Testers

Magnetic Field Detectors

Power Line Analyzers

Signal Generators

Digital Oscilloscopes

Environmental Measures

Thermometers and Sensors

IR Thermal Imaging Cameras

Hygrometers

Anemometers and Pressure Gauges

Phonometers

Luxmeters

Chemical-Physical Characteristics

Set of Measuring Instruments

Tripods

Carrying cases

Accessories

There are 38 products.

Sort by:

PeakTech MKS-1 - Coaxial Test Cable 100cm BNC/Banana Plug

Coaxial Test Cable 100 cm BNC/4mm Banana Plug Coaxial cable, length 1 m, BNC to 4 mm Banana Plug

$9.66

PeakTech 7005 - Pair of Test Leads 100cm 1000V 10A with Plugs 4mm and Extension

Pair of Test Leads 100cm 1000V 10A with Plugs 4mm and Extension This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. Maximum safety is achieved through the double insulation of the wires and the contact protection against conductive metal parts in the closed state. Thus, this accessory is perfectly suitable for use in training and service area.

$9.66

PeakTech 7015 - Pair of Alligator Clamps 1000V 10A for Plugs 4mm

Pair of Alligator Clamps 1000V 10A for Plugs 4mm This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. This accessory is perfectly suitable for use in training and service area.

$9.66

PeakTech 7035 - Pair of Cables with Crocodile Clips for Low Voltage Laboratory Power Supplies

Pair of Cables with Alligator Clips for Low Voltage Laboratory Power Supplies These cables with 4 mm banana plugs are suitable for use in SELV / PELV low voltage circuits and are therefore particularly suitable for low voltage laboratory power supplies. At one end they have a 4mm banana plugs, each both male and female (stackable) not insulated, at the other end they have an alligator clip to connect the load.

$9.66

PeakTech 7045 - Pair of Stackable Cables for Low Voltage Laboratory Power Supplies

Pair of Stackable Cables for Low Voltage Laboratory Power Supplies These cables with 4 mm banana plugs are suitable for use in SELV / PELV low voltage circuits and are therefore particularly suitable for low voltage laboratory power supplies. At both ends they have 4 mm banana plugs, each both male and female (stackable), not insulated.

$10.74

PeakTech MKS-10 - Pair of Test Probes with 1 mm Diameter Tip and Crocodiles, for 4 mm Plugs, 1000 V 10 A

Pair of Test Probes with 1 mm Diameter Tip and Crocodiles, for 4 mm Plugs, 1000 V 10 A. Set of two test probes, red and black, with a thin tip of 1 mm in diameter that allows measurements even on small components, 4 mm safety socket. Also included are 2 crocodiles which can be inserted on the tips.

$11.83

PeakTech 5315PR - Replacement Electrode for pH-Meter 5315

Replacement Electrode for pH-Meter PeakTech 5315

$14.00

PeakTech 7055 - BNC Female to 4mm Sockets Adapter

BNC Female to 4mm Sockets Adapter This adapter has a connector BNC male and two 4mm sockets It is intended to connect oscilloscopes and test accessories with 4mm banana plugs, such as current clamp adapters. This accessory is ideal for use in the service and educational sector.

$15.08

PeakTech 7030 - Pair of Safety Cables for Laboratory Power Supplies

Pair of Safety Cables for Laboratory Power Supplies These safety cables with 4 mm banana plugs are particularly suitable for laboratory power supplies. At both ends they have 4 mm banana plugs, each both male and female (stackable).

$15.08

PeakTech 7000 - Pair of Hook Probes 15cm 1000V 10A for Plugs 4mm

Pair of Hook Probes 15cm 1000V 10A for Plugs 4mm This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. This accessory is perfectly suitable for use in training and service area.

$17.25

PeakTech 4200 - Clamp Adaptor AC for Multimeter, 200 A, 16 mm, with 4 mm Plugs

Clamp Adaptor AC for Multimeter, 200 A, 16 mm, with 4 mm Plugs This clamp adaptor is a transducer, which allows to measure electrical current AC by connection with a digital multimeter. When measuring current with this clamp adaptor, it is no need to break a circuit or to affect the insulation. This adaptor with a design of finger guard, ensures user operating under condition safe.

$17.25

PeakTech 5315 - pH-Meter 0.00 - 14.00 with Backlight

pH-Meter 0.00 - 14.00 with Backlight The PeakTech 5315 pH-meter has a long and thin measuring probe specially developed for laboratory use, which can be used for flasks, beakers or cylinders. The probe can be easily removed thanks to its screw attachment. The LCD display is backlit and is easily readable. In the upper part there are the On/Off switch and two trimmers for pH 7 and pH 4 calibration. The two necessary buffer solutions for calibration are included.

$34.62

5305A - pH-Meter and Thermometer (2-in-1)

pH-Meter and Thermometer (2-in-1) The PeakTech 5305A is a 2-in-1 pH meter that is operated with one hand and measures the pH and temperature in °C or °F of liquids at the same time. Both measured quantities are displayed on the LCD display with permanent backlight. Attached to the sturdy and waterproof housing is the easily replaceable sensor head, which includes the sensor for measurement of PH and temperature.

$36.79

PeakTech 3705 - Digital Capacity Tester, 3 ½ digits, 8/80/800Hz

Digital Capacity Tester, 3 ½ digits, 8/80/800Hz Digital capacity meter is a 3 ½ digits with steady operations, fashionable design and highly reliable hand held measuring instrument. The meter can also measure resistance, transistor, diode and continuity with buzzer; has a broad capacitance measurement range, precise accuracy and can be used in to measure the circuit designed capacitance of cables, switch and PCB layout.

$40.04

PeakTech 1041 - Digital Multimeter, 3 ¾ digits (3999), Auto Range, TrueRMS, Contactless Detector, Multifunction

Digital Multimeter, 3 ¾ digit (3999), Automatic Range, True RMS, Contactless Detector, Capacimeter, Frequency Meter, Thermometer Compact 3 ¾ digit multimeter with protective shell, True RMS, multifunction. LCD display, 3 ¾ digit, max. 3999 True RMS Value Measurements DC and AC voltages up to 600V DC and AC currents up to 10 A Automatic or Manual Range Data Hold, Minimum and Maximum, Relative Value Auto shutdown Battery charge status indication Fuse in the battery compartment Sturdy double shell container Compliant with safety standards: EN 61010-1; CAT III 600V / CAT IV 300V Diode and continuity test Test 1.5V and 9V batteries Accessories: carrying case, test leads, 2 x AAA 1.5 V batteries, manual

$41.13

PeakTech 3349 - Digital Multimeter, 3 5/6 digits (5999) 22mm, TrueRMS, Capacimeter, Frequency Meter, Thermometer K, NCV Detector

Digital Multimeter, 3 5/6 digit (5999), True RMS, Capacimeter, Frequency Meter, Thermometer K, NCV Detector The PeakTech 3349 offers a variety of useful functions that simplify daily work, especially in dark or noisy environments. The lighting of the large LCD display is automatically activated by a photodiode in dark surroundings. On the back of the device there is also a bright LED flashlight for illuminating the measurement area. A multi-colored LED bar is located above the display. Depending on the active measuring function, it lights up green during the continuity test, red when a voltage is detected in "Non-Contact Voltage Detection" (NCV) mode, yellow when measuring large capacities or flashes red when the phase is detected in "Single-Pole Phase Testing" (LIVE) mode.

$45.47

PeakTech 3710 - R/C Pen Meter for SMD, 3 5/6 digits (5999) 11 mm

Pen Capacimeter and Ohmmeter for SMD, 3 5/6 digits (5999) 11 mm Auto scan pen meter in a set of tweezers for SMD measure precise and fast small chip components, ideal for use in the service and education fields.

$46.55

Meter of pH, Electrical Conductivity (EC) and Temperature (3-in-1)

Meter of pH, Electrical Conductivity (EC) and Temperature (3-in-1) The PeakTech 5306 is a 3-in-1 pH meter that is operated with one hand and measures, at the same time, the pH or the Electric Conductivity (EC) in µS/cm, and the temperature in °C or °F, of liquids. Both measured quantities are displayed on the LCD display with permanent backlight. Attached to the rugged and waterproof housing is the easily replaceable sensor head, which includes the sensor for PH or EC measurement and temperature measurement.

$46.55

PeakTech 8200 - Measurement Accessories Set

Measurement Accessories Set This extensive collection of test accessories for the electronics area provides the best suitable measuring adapter for the desired application for each digital multimeter. In addition, these high quality clips and cables are all manufactured to the latest safety standards and provides a high safety in every application for the user. For the material, a flexible and non-slip plastic was chosen, which can also withstand the hardest kinds of usage.

$47.64

PeakTech 3350 - Digital Multimeter, 3 5/6 digits (5999) 22mm, AutoRange, TrueRMS, Capacimeter, Frequency Meter, Thermometer K

Digital Multimeter, 3 5/6 digit (5999), AutoRange, True RMS, Capacimeter, Frequency Meter, Thermometer K, NCV Detector The PeakTech 3350 offers a variety of useful functions that simplify daily work, especially in dark or noisy environments. The lighting of the large LCD display is automatically activated by a photodiode in dark surroundings. On the back of the device there is also a bright LED flashlight for illuminating the measurement area. A multi-colored LED bar is located above the display. Depending on the active measuring function, it lights up green during the continuity test, red when a voltage is detected in "Non-Contact Voltage Detection" (NCV) mode, yellow when measuring large capacities or flashes red when the phase is detected in "Single-Pole Phase Testing" (LIVE) mode.

$51.98

Showing 1-20 of 38 item(s)