Home

Digital Clamp Multimeters

Digital Voltmeter Modules

Cables, Probes, Bags

Fuses for Multimeters

Milliohmmeters

LCR Meters and Component Testers

Energy Meters

Insulation Meters

Earth Resistance Meters

Electrical Installation Safety Testers

Cables-Voltage-Phase Testers

Magnetic Field Detectors

Power Line Analyzers

Signal Generators

Digital Oscilloscopes

Environmental Measures

Thermometers and Sensors

IR Thermal Imaging Cameras

Hygrometers

Anemometers and Pressure Gauges

Phonometers

Luxmeters

Chemical-Physical Characteristics

Set of Measuring Instruments

Tripods

Carrying cases

Accessories

There are 42 products.

Sort by:

PeakTech MKS-1 - Coaxial Test Cable 100cm BNC/Banana Plug

Coaxial Test Cable 100 cm BNC/4mm Banana Plug Coaxial cable, length 1 m, BNC to 4 mm Banana Plug

$9.66

PeakTech 7005 - Pair of Test Leads 100cm 1000V 10A with Plugs 4mm and Extension

Pair of Test Leads 100cm 1000V 10A with Plugs 4mm and Extension This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. Maximum safety is achieved through the double insulation of the wires and the contact protection against conductive metal parts in the closed state. Thus, this accessory is perfectly suitable for use in training and service area.

$9.66

PeakTech 7015 - Pair of Alligator Clamps 1000V 10A for Plugs 4mm

Pair of Alligator Clamps 1000V 10A for Plugs 4mm This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. This accessory is perfectly suitable for use in training and service area.

$9.66

PeakTech 7035 - Pair of Cables with Crocodile Clips for Low Voltage Laboratory Power Supplies

Pair of Cables with Alligator Clips for Low Voltage Laboratory Power Supplies These cables with 4 mm banana plugs are suitable for use in SELV / PELV low voltage circuits and are therefore particularly suitable for low voltage laboratory power supplies. At one end they have a 4mm banana plugs, each both male and female (stackable) not insulated, at the other end they have an alligator clip to connect the load.

$9.66

PeakTech 7045 - Pair of Stackable Cables for Low Voltage Laboratory Power Supplies

Pair of Stackable Cables for Low Voltage Laboratory Power Supplies These cables with 4 mm banana plugs are suitable for use in SELV / PELV low voltage circuits and are therefore particularly suitable for low voltage laboratory power supplies. At both ends they have 4 mm banana plugs, each both male and female (stackable), not insulated.

$10.74

PeakTech MKS-10 - Pair of Test Probes with 1 mm Diameter Tip and Crocodiles, for 4 mm Plugs, 1000 V 10 A

Pair of Test Probes with 1 mm Diameter Tip and Crocodiles, for 4 mm Plugs, 1000 V 10 A. Set of two test probes, red and black, with a thin tip of 1 mm in diameter that allows measurements even on small components, 4 mm safety socket. Also included are 2 crocodiles which can be inserted on the tips.

$11.83

PeakTech 1030 - Voltage Detector 50 - 1000 V AC non Contact, with Buzzer

Voltage Detector 50 - 1000 V AC non Contact, with Buzzer Easy to use, for non-contact detection of AC voltage from 90 V to 1000 V. Suitable for outlets or for wire insulation testing. Suitable for conductor tracking of flush-mounted cables and localisation of line interruptions. If AC-voltage is at the measuring point, it is visually indicated by a flashing red LED and the integrated buzzer sounds. The probe lights green when the measuring point is free of voltage.

$12.91

PeakTech 5315PR - Replacement Electrode for pH-Meter 5315

Replacement Electrode for pH-Meter PeakTech 5315

$14.00

PeakTech 7055 - BNC Female to 4mm Sockets Adapter

BNC Female to 4mm Sockets Adapter This adapter has a connector BNC male and two 4mm sockets It is intended to connect oscilloscopes and test accessories with 4mm banana plugs, such as current clamp adapters. This accessory is ideal for use in the service and educational sector.

$15.08

PeakTech 7030 - Pair of Safety Cables for Laboratory Power Supplies

Pair of Safety Cables for Laboratory Power Supplies These safety cables with 4 mm banana plugs are particularly suitable for laboratory power supplies. At both ends they have 4 mm banana plugs, each both male and female (stackable).

$15.08

PeakTech 4200 - Clamp Adaptor AC for Multimeter, 200 A, 16 mm, with 4 mm Plugs

Clamp Adaptor AC for Multimeter, 200 A, 16 mm, with 4 mm Plugs This clamp adaptor is a transducer, which allows to measure electrical current AC by connection with a digital multimeter. When measuring current with this clamp adaptor, it is no need to break a circuit or to affect the insulation. This adaptor with a design of finger guard, ensures user operating under condition safe.

$17.25

PeakTech 7000 - Pair of Hook Probes 15cm 1000V 10A for Plugs 4mm

Pair of Hook Probes 15cm 1000V 10A for Plugs 4mm This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. This accessory is perfectly suitable for use in training and service area.

$17.25

PeakTech 1031 - Voltage Detector 50 - 1000 V AC Contactless with Buzzer, Vibration and LED Flashlight

Voltage Detector 50 - 1000 V AC Contactless with Buzzer, Vibration and LED Flashlight Voltage Detector for the contactless detection of AC voltages on live cables and devices. By switching the measuring range, it is possible to detect even low voltages down to a minimum of 50V AC. When the display shows "Working" you can be sure that the detector is working and detects if there is voltage. The voltage detection is indicated by the flashing of the yellow or red LED, by the sound of the buzzer and the vibration of the detector. The voltage detection cannot escape even in noisy environments. The integrated LED flashlight can be switched on at any time, even if the voltage detector is switched off. In addition, the device can be carried comfortably and safely with its pocket clip.

$18.34

PeakTech 1032 - Voltage Detector 12 - 1000 V AC Contactless with Buzzer, Vibration and LED Flashlight

Voltage Detector 12 - 1000 V AC Contactless with Buzzer, Vibration and LED Flashlight Voltage Detector for the contactless detection of AC voltages on live cables and devices. By switching the measuring range, it is possible to detect even low voltages down to a minimum of 12V AC. When the display shows "Working" you can be sure that the detector is working and detects if there is voltage. The voltage detection is indicated by the flashing of the yellow or red LED, by the sound of the buzzer and the vibration of the detector. The voltage detection cannot escape even in noisy environments. The integrated LED flashlight can be switched on at any time, even if the voltage detector is switched off. In addition, the device can be carried comfortably and safely with its pocket clip.

$23.77

PeakTech 1020A - Digital Multimeter, 3 ½ digits (1999) 12mm, Non-contact Voltage Detection, Automatic Fuse, LED-Flashlight

Digital Multimeter, 3 ½ digits (1999) 12mm, Non-contact Voltage Detection, Automatic Fuse, LED-Flashlight An easy to use and safe Multimeter with integrated protection frames, pocket sized for AC/DC voltage, current and resistance measurements, and non-contact voltage detection, with built-in flashlight. This devices uses an self-resetting PTC fuse for it's mA measurement range.

$31.36

PeakTech 5315 - pH-Meter 0.00 - 14.00 with Backlight

pH-Meter 0.00 - 14.00 with Backlight The PeakTech 5315 pH-meter has a long and thin measuring probe specially developed for laboratory use, which can be used for flasks, beakers or cylinders. The probe can be easily removed thanks to its screw attachment. The LCD display is backlit and is easily readable. In the upper part there are the On/Off switch and two trimmers for pH 7 and pH 4 calibration. The two necessary buffer solutions for calibration are included.

$34.62

5305A - pH-Meter and Thermometer (2-in-1)

pH-Meter and Thermometer (2-in-1) The PeakTech 5305A is a 2-in-1 pH meter that is operated with one hand and measures the pH and temperature in °C or °F of liquids at the same time. Both measured quantities are displayed on the LCD display with permanent backlight. Attached to the sturdy and waterproof housing is the easily replaceable sensor head, which includes the sensor for measurement of PH and temperature.

$36.79

PeakTech 1095 - Voltage Tester from 12 to 690 V DC/AC with LED's and Beeper

Voltage Tester from 12 to 690 V DC/AC with LED's and Beeper TÜV/GS-approved 2-pole voltage tester with LED-display for DC and AC measurement from 12 V to 690 V provides further a wide range of measurement functions. The highlights are the measuring point illumination, continuity test with visual and audible signal and the phase and direction indicator.

$42.21

PeakTech 3434 - Acoustic Wire Detector with Tone Generator

Acoustic Wire Detector with Tone Generator This new cable finder works acoustically and provides a fast and cost-effective solution for finding voltage-free lines in house installations, testing telephone lines and identifying individual cables / wires or performing a continuity test. With the transmitter / sound generator, a carrier signal is modulated to an electrical conductor, which you can track with the receiver / amplifier with built-in speaker or via a headphone jack. You can also control the sensitivity using a rotary knob on the receiver to achieve the best possible identification even with coring wires. When connected to a telephone jack via the RJ-11 connector, the LED of the transmitter indicates the status of the active telephone line between "free", "busy" or...

$45.47

Meter of pH, Electrical Conductivity (EC) and Temperature (3-in-1)

Meter of pH, Electrical Conductivity (EC) and Temperature (3-in-1) The PeakTech 5306 is a 3-in-1 pH meter that is operated with one hand and measures, at the same time, the pH or the Electric Conductivity (EC) in µS/cm, and the temperature in °C or °F, of liquids. Both measured quantities are displayed on the LCD display with permanent backlight. Attached to the rugged and waterproof housing is the easily replaceable sensor head, which includes the sensor for PH or EC measurement and temperature measurement.

$46.55

Showing 1-20 of 42 item(s)