Home

Digital Clamp Multimeters

Digital Voltmeter Modules

Cables, Probes, Bags

Fuses for Multimeters

Milliohmmeters

LCR Meters and Component Testers

Energy Meters

Insulation Meters

Earth Resistance Meters

Electrical Installation Safety Testers

Cables-Voltage-Phase Testers

Magnetic Field Detectors

Power Line Analyzers

Signal Generators

Digital Oscilloscopes

Environmental Measures

Thermometers and Sensors

IR Thermal Imaging Cameras

Hygrometers

Anemometers and Pressure Gauges

Phonometers

Luxmeters

Chemical-Physical Characteristics

Set of Measuring Instruments

Tripods

Carrying cases

Accessories

There are 23 products.

Sort by:

PeakTech MKS-1 - Coaxial Test Cable 100cm BNC/Banana Plug

Coaxial Test Cable 100 cm BNC/4mm Banana Plug Coaxial cable, length 1 m, BNC to 4 mm Banana Plug

$9.66

PeakTech LDP-340 - Voltmeter, 3 ½ digits LCD backlight, 8 mm digit height, 200 mV DC

Voltmeter, 3 ½ digits LCD backlight, 8 mm digit height, 200 mV DC

$9.66

PeakTech LDP-240 - Voltmeter, 3 ½ digits green LED, 13 mm digit height, 200 mV DC

Voltmeter, 3 ½ digits red LED, 13 mm digit height, 200 mV DC

$15.08

PeakTech LDP-235 - Voltmeter, 3 ½ digits red LED, 13 mm digit height, 200 mV DC

Voltmeter, 3 ½ digits red LED, 13 mm digit height, 200 mV DC

$12.91

PeakTech 9035 - Power Meter

Energy / Power Meter New designed, high-precison Energy Meter for detecting the energy consumption of electrical appliances and to calculate the total cost of the electricity consumption of a device by entering the current price. Through the integrated power factor calculation all modern electronic consumers such as switching power supplies, TVs, fluorescent lights, LED systems and of course, resistive loads such as electrical heaters and hobs are precisely measured. In addition, due to the high resolution and the low response, even very small or standby loads are measured from approximately 1W.

$16.17

PeakTech 7736 - Ceramic Fuse F, 10A 300V 5x20mm, 10 Pieces

Ceramic Fuse F, 10A 300V 5x20mm 2 , 10 Pieces Modern Safety Fuse with ceramic body provide a much higher level of protection against damage to the measurement devices when triggered than regular glass fuses. Blown fuse may only be replaced with spare fuses of the same type and specifications to ensure the safety of the devices and thus the safety of the user during following measurements.

$16.17

PeakTech 7706 - Ceramic Fuse F, 250mA 300V 5x20mm, 10 Pieces

Ceramic Fuse F, 250mA 300V 5x20mm 2 , 10 Pieces Modern Safety Fuse with ceramic body provide a much higher level of protection against damage to the measurement devices when triggered than regular glass fuses. Blown fuse may only be replaced with spare fuses of the same type and specifications to ensure the safety of the devices and thus the safety of the user during following measurements.

$15.08

PeakTech 7700 - Ceramic Fuse F, 100mA 250V 5x20mm, 10 Pieces

Ceramic Fuse F, 100mA 250V 5x20mm 2 , 10 Pieces Modern Safety Fuse with ceramic body provide a much higher level of protection against damage to the measurement devices when triggered than regular glass fuses. Blown fuse may only be replaced with spare fuses of the same type and specifications to ensure the safety of the devices and thus the safety of the user during following measurements.

$15.08

PeakTech 7630 - Ceramic Fuse FF, 20A 250V 6.3x32mm, 10 Pieces

Ceramic Fuse FF, 20A 250V 6.3x32mm 2 , 10 Pieces Modern Safety Fuse with ceramic body provide a much higher level of protection against damage to the measurement devices when triggered than regular glass fuses. Blown fuse may only be replaced with spare fuses of the same type and specifications to ensure the safety of the devices and thus the safety of the user during following measurements.

$16.17

PeakTech 7625 - Ceramic Fuse FF, 12.5A 500V 6.3x32mm, 10 Pieces

Ceramic Fuse FF, 12.5A 500V 6.3x32mm 2 , 10 Pieces Modern Safety Fuse with ceramic body provide a much higher level of protection against damage to the measurement devices when triggered than regular glass fuses. Blown fuse may only be replaced with spare fuses of the same type and specifications to ensure the safety of the devices and thus the safety of the user during following measurements.

$16.17

PeakTech 7620 - Ceramic Fuse FF, 10A 500V 6.3x32mm, 10 Pieces

Ceramic Fuse FF, 10A 500V 6.3x32mm 2 , 10 Pieces Modern Safety Fuse with ceramic body provide a much higher level of protection against damage to the measurement devices when triggered than regular glass fuses. Blown fuse may only be replaced with spare fuses of the same type and specifications to ensure the safety of the devices and thus the safety of the user during following measurements.

$15.08

PeakTech 7510 - Ceramic Fuse FF, 500mA 1000V 6.3x32mm, 10 Pieces

Ceramic Fuse FF, 500mA 1000V 6.3x32mm 2 , 10 Pieces Modern Safety Fuse with ceramic body provide a much higher level of protection against damage to the measurement devices when triggered than regular glass fuses. Blown fuse may only be replaced with spare fuses of the same type and specifications to ensure the safety of the devices and thus the safety of the user during following measurements.

$12.91

PeakTech 7055 - BNC Female to 4mm Sockets Adapter

BNC Female to 4mm Sockets Adapter This adapter has a connector BNC male and two 4mm sockets It is intended to connect oscilloscopes and test accessories with 4mm banana plugs, such as current clamp adapters. This accessory is ideal for use in the service and educational sector.

$15.08

PeakTech 7035 - Pair of Cables with Crocodile Clips for Low Voltage Laboratory Power Supplies

Pair of Cables with Alligator Clips for Low Voltage Laboratory Power Supplies These cables with 4 mm banana plugs are suitable for use in SELV / PELV low voltage circuits and are therefore particularly suitable for low voltage laboratory power supplies. At one end they have a 4mm banana plugs, each both male and female (stackable) not insulated, at the other end they have an alligator clip to connect the load.

$9.66

PeakTech 7030 - Pair of Safety Cables for Laboratory Power Supplies

Pair of Safety Cables for Laboratory Power Supplies These safety cables with 4 mm banana plugs are particularly suitable for laboratory power supplies. At both ends they have 4 mm banana plugs, each both male and female (stackable).

$15.08

PeakTech 7015 - Pair of Alligator Clamps 1000V 10A for Plugs 4mm

Pair of Alligator Clamps 1000V 10A for Plugs 4mm This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. This accessory is perfectly suitable for use in training and service area.

$9.66

PeakTech 7005 - Pair of Test Leads 100cm 1000V 10A with Plugs 4mm and Extension

Pair of Test Leads 100cm 1000V 10A with Plugs 4mm and Extension This new product of test accessories in 4 mm technique can be combined with almost all measuring devices, generators and power supplies. Maximum safety is achieved through the double insulation of the wires and the contact protection against conductive metal parts in the closed state. Thus, this accessory is perfectly suitable for use in training and service area.

$9.66

PeakTech 4935 - Mini IR Thermometer -50°C to +400°C - 12:1 Distance / Measurement Area Diameter

Mini IR Thermometer -50°C to +400°C - Distance to Measuring Spot Ratio 12:1 * Not suitable for human body temperature measurement * Handy infrared thermometer with an excellent price-performance ratio that measures surface temperatures quickly, easily and accurately using a built in laser pointer. The laser can be aimed at hot surfaces or moving objects, allowing the operator to easily capture the temperatures to be measured from a safe distance. The thermometer is activated by a trigger and carries out a precise (0.1°C resolution) temperature measurement in a flash. The three function keys next to the screen toggle between °C and °F, activate the laser and the backlight of the display.

$17.91

PeakTech 4200 - Clamp Adaptor AC for Multimeter, 200 A, 16 mm, with 4 mm Plugs

Clamp Adaptor AC for Multimeter, 200 A, 16 mm, with 4 mm Plugs This clamp adaptor is a transducer, which allows to measure electrical current AC by connection with a digital multimeter. When measuring current with this clamp adaptor, it is no need to break a circuit or to affect the insulation. This adaptor with a design of finger guard, ensures user operating under condition safe.

$17.25

PeakTech 1070 - Digital Multimeter, 3 ½ digits (1999) 12mm

Digital Multimeter, 3 ½ digits (1999) 12mm, Thermometer TÜV/GS approved pocket size digital multimeter in modern design. Suitable for technicians and hobbyists.

$18.34

Showing 1-20 of 23 item(s)